Recycling sewage sludge into ceramic materials: A review

Environmental Chemistry Letters - Huge amounts of unwanted sewage sludge are generated in the process of wastewater treatment, calling for methods to recycle sewage sludges into value-added...     

A combined radical and non-radical oxidation processes for efficient degradation of Acid Orange 7 in the homogeneous Cu(II)/PMS system: important role of chloride

Environmental Science and Pollution Research - Trace copper ion (Cu(II)) in water and wastewater can trigger peroxymonosulfate (PMS) activation to oxidize organic compounds, but it only works under...     

An asymmetric analysis of the impacts of energy use on carbon dioxide emissions in the G7 countries

Environmental Science and Pollution Research - The foremost theme of the paper is to explore the asymmetric/symmetric impact of energy consumption on the carbon dioxide emission of G7 countries...     

Research progress and hot spots of hydrothermal liquefaction for bio-oil production based on bibliometric analysis

Environmental Science and Pollution Research - Hydrothermal liquefaction (HTL) of biomass used HTL reaction under high temperature and pressure to produce bio-oil. This technology is considered as...     

氨废水资源化利用的折流式超重力床集成技术

利用折流式超重力床将氨废水处理的精馏和吸收过程集成在一台设备中,开发出一种设备小型化、流程紧凑的氨废水资源化利用集成技术。与传统技术相比,该技术在大幅节省占地面积和空间的同时,还可大幅节约设备建设所用钢材。工业规模试验结果表明,不同浓度的氨废水经该技术处理后可转化为氨质量分数大于22%的氨水资源,处理出水中氨氮质量浓度低于8.2 mg/L,尾气中未检测到氨,处理结果优于GB 31573—2015《无机化学工业污染物排放标准》。     

地铁区间隧道烟气层化现象研究

以重庆某一地铁区间隧道为原型,搭建了1∶15小尺寸隧道试验台,通过小尺寸试验与FDS 6.5.2数值模拟开展隧道顶部烟气温度分布及分层规律研究。基于Newman提出的烟气层分区条件,研究了不同纵向风速下的烟气分层现象,提出了烟气稳定层化长度的概念,并分析了火源热释放速率及断面型式对烟气层化长度的影响。试验证明了Newman提出的烟气分层计算方法是可信的。结果表明:纵向风速较小时,火源下游能呈现烟气分层现象;烟气稳定层化长度受火源热释放速率影响较大,随热释放速率增大而增大;隧道高度的变化对烟气稳定层化长度的影响较小。     

Carbon Emission from the Surface of Coarse Woody Debris in Korean Pine Forests of Southern Primorye

Carbon dioxide fluxes from the surface of coarse woody debris (CWD) have been measured in Korean pine forests of the southern Sikhote-Alin mountain range. The seasonal dynamics of oxidative conversion of CWD carbon have been evaluated, and average values of the CO₂ emission rate have been determined for CWD fragments of three tree species at different stages of decomposition. The degree of decomposition is an important factor of spatial variation in CO₂ emission rate, and temporal variation in this parameter is adequately described by an exponential function of both CWD temperature and air temperature (R² = 0.65–0.75).     

Heat dissipation characteristic in the intake grille and radiator of a fuel cell vehicle

ABSTRACT

In this study, a three-dimension (3D) computational model was proposed to investigate the flow and heat transfer characteristics of the intake grilles of two different fuel cell vehicles. The models of the intake grilles were constructed according to the actual sizes of two vehicles, namely, Roewe 950 and Toyota Mirai, considering the heat dissipation unit to simplify the heat transfer model of the vehicle. The results showed that relative to Roewe 950, Mirai intake air flow rate was approximately 10% higher, the heat transfer capacity was approximately 7% higher, and the intake grille area was larger. The coolant outlet temperature of Mirai was lower than that of Roewe 950, which was beneficial for the long term and stable operation of a fuel cell. This comparative study provided guidance for the intake grille and radiator design of fuel cell vehicles. The only difference between fuel cell vehicles on the market and conventional vehicles was that in the former, the internal combustion engine was replaced with a fuel cell stack, which had insufficient heat transfer capacity because of the reducing temperature difference. Increasing the intake grille area and the heat exchange capacity of the radiator were the key issues for the development of fuel cell vehicles. In this study, an optimal window opening angle of the radiator fin of 23° provided a maximal heat transfer coefficient.     

高效液相色谱-电感耦合等离子体质谱测定大米粉中的硒形态

建立了高效液相色谱-电感耦合等离子体质谱联用技术(HPLC-ICP-MS)测定大米粉中硒代胱氨酸(SeCys_2)、甲基-硒代半胱氨酸(MeSeCys)、亚硒酸根(Se(Ⅳ))、硒代蛋氨酸(SeMet)、硒酸根(Se(Ⅵ))等5种硒形态的分析方法.采用Hamilton PRP-X100分析柱,以pH 4和pH 6的20 mmol·L~(-1)的柠檬酸溶液辅以少量甲醇为流动相,在梯度洗脱条件下,9 min内可实现5种硒形态完全分离.SeCys_2、MeSeCys、Se(Ⅳ)、SeMet、Se(Ⅵ)的检出限分别为0.88、0.69、1.00、0.90、0.82μg·L~(-1).利用富硒小麦粉标准物质RM8436探讨了不同提取方式的提取效果.最终确定75 mmol·L~(-1) Tris-HCl(pH 7.5)添加XIV蛋白酶和Driselase酶作为提取剂,在37℃振荡提取3 h为大米样品前处理方法.利用该方法分析了富硒地区大米粉中的硒形态,结果表明,大米粉中的硒主要以有机硒形态为主,其中SeMet是最主要的硒形态,占总硒的90%左右.     

Determination of 27 pharmaceuticals and personal care products (PPCPs) in water: The benefit of isotope dilution

• Isotope dilution method was developed for the determination of 27 PPCPs in water. • The established method was successfully applied to different types of water samples. • The correction effect of corresponding 27 ILSs over 70 d was investigated. • Benefit of isotopic dilution method was illustrated for three examples. Pharmaceuticals and personal care products (PPCPs) are a unique group of emerging and non-persistent contaminants. In this study, 27 PPCPs in various water samples were extracted by solid phase extraction (SPE), and determined by isotope dilution method using liquid chromatography coupled to tandem triple quadruple mass spectrometer (LC-MS/MS). A total of 27 isotopically labeled standards (ILSs) were applied to correct the concentration of PPCPs in spiked ultrapure water, drinking water, river, effluent and influent sewage. The corrected recoveries were 73%–122% with the relative standard deviation (RSD)<16%, except for acetaminophen. The matrix effect for all kinds of water samples was<22% and the method quantitation limits (MQLs) were 0.45–8.6 ng/L. The developed method was successfully applied on environmental water samples. The SPE extracts of spiked ultrapure water, drinking water, river and wastewater effluent were stored for 70 days, and the ILSs-corrected recoveries of 27 PPCPs were obtained to evaluate the correction ability of ILSs in the presence of variety interferences. The recoveries of 27 PPCPs over 70 days were within the scope of 72%–140% with the recovery variation<37% in all cases. The isotope dilution method seems to be of benefit when the extract has to be stored for long time before the instrument analysis.